Racertech Polaris RZR Lift Kit
Introducing the new Racer Tech 2" RZR Lift Kit. It was brought to our attention that almost EVERY lift kit on the market has been causing serious CV and boot damage in short time. This is just ridiculous... A company should have tested proven and functional products. Not slapped together junk. Here at Racer Tech we do things right the first time, period. With that said, we are proud to present the first lift kit that WILL NOT cause any CV issues for the remainder of the life of your RZR. We know this because we've tested the kit and can honestly say the rear will not droop any lower than the factory setup. We achieve this by relocating the UPPER shock mounts and not the lowers. This method improves the shock angles which require a lower spring rate to hold the vehicle at ride height. When retaining the stock springs however, the ride height is raised. This kit will allow you to back the "clickers" on your shocks down and still have the desired height needed for that additional ground clearance. So you get two things with this kit. A taller ride height PLUS an improved ride! Actual height gains will vary but expect approximately 1.5” rear lift and 2” front. We’ve found our best performance with these machines by setting the fronts 0.5-1” taller.
Another improvement we make with this kit is correcting the front sway bar travel. This may not be extremely noticeable to most, but it’s just another way Racer Tech takes care of business!,
This kit is all bolt-on and the installation can be completed in less than 1.5 hours. There are four holes to be drilled in the rear of the frame for the ultimate in strength but this job is made simple by the very thorough instructions this kit comes with. This kit comes complete with all necessary components, hardware and instructions for complete installation. Kits are powdercoated your choice of Black, RZR Red or LE Silver. THIS KIT WILL FIT RZR, RZR S or RZR 4. Please select which model you have below when purchasing.
If you have a RZR S or RZR 4 you do not need the sway bar links which come with the standard RZR kit. RZR S and RZR 4 are the same kit. AVAILABLE NOW!: Quick Disconnect front sway bar kit - This can be an upgrade to your existing kit!